济南彩钢板

10年品牌值得信赖
精诚团结、奋起拼搏、开拓进取

济南彩钢板

13969159292

0531-88686388

新闻中心

首页>>新闻中心>>如何制作彩钢瓦房顶的骨架?
新闻中心
联系我们
济南坚固彩钢工程公司

联系人:

电话:13969159292

地址:济南市工业北路81号北邻

如何制作彩钢瓦房顶的骨架?

来源:http://www.jnjgcg.com/ 日期:2020-05-13 发布人:admin
  彩钢瓦房顶的骨架可谓是建筑的核心,因此对于它的制作方法有着高标准、高要求,本文就为大家介绍了如何制作彩钢瓦房顶的骨架,希望施工人员能够认真阅读。
  The framework of the colored steel tile roof is the core of the building, so there are high standards and high requirements for its production methods. This paper introduces how to make the framework of the colored steel tile roof, hoping that the construction personnel can read it carefully.
  一、屋面
  1、 Roof
  以山墙边做起点,由左而右(或同右而左)依顺序铺设。然后片板安置完毕后,沿板下缘拉准线,每片依准线安装,随时检查不使发生偏离。铺设面以自攻螺丝,沿每一板肋固定于衍条上。
  Starting from the gable side, it is laid from left to right (or the same as right to left). Then, after the first plate is placed, pull the alignment along the lower edge of the plate, and install each plate according to the alignment, and check at any time to avoid deviation. Finally, the laying surface is fixed on the strip along the center of each plate rib with self tapping screws.
  二、收边
  2、 Close edge
  屋面(含雨蓬)收边料搭接处,须以铝拉钉固定及止水胶防水。然后屋面收边平板自攻螺丝头及铝拉钉头,须以止水胶防止。收边板施工固定方式,依其现场丈量需做变更时,以确认后制做图为准。
  The lap joint of roof (including canopy) trimming material shall be fixed with aluminum rivet and waterproof with water stop glue. Then, the self tapping screw head and aluminum rivet head of the roof edge closing plate shall be prevented by water stop glue. Finally, the construction and fixing method of the edge plate shall be changed according to the site measurement, and the drawing after confirmation shall prevail.
济南彩钢瓦厂
  三、固定方法
  3、 Fixation method
  排个固定座,以自攻螺丝固定于檩条更左边,然后于檩条弹墨线做基准线,接着固定同排固定座。接着块板之肋部对准固定座之肋板,压下卡入检查是否扣合正确。然后将固定座短臂扣上块已铺好之面板阴肋,依前述方法施工,并调整。按上述顺序铺设,所剩空中楼阁间小于板宽一半时,仅用固定座短臂固定板片,其余空间以泛水收头。如所剩空间大于板宽一半时,则以固定座固定板片,其超出部分裁除。
  The first fixed base in the first row is fixed on the left most side of the purlin with self tapping screws, then the ink line is snapped on the purlin as the reference line, and then the fixed base in the same row is fixed. Next, align the rib part of the first plate with the rib plate of the fixed seat, press down and clip in to check whether the buckle is correct. Then, buckle the short arm of the fixed seat onto the first paved inner rib of the panel, construct according to the above method, and adjust. According to the above sequence of laying, when the width of the remaining empty pavilions is less than half of the board width, only the short arm of the fixed base is used to fix the board, and the rest of the space is closed by flashing. If the last remaining space is more than half the width of the plate, the plate shall be fixed with a fixed seat, and the excess part shall be cut off.
  施工人员在以后的施工工程中希望能够严格按照上文所讲述的方法进行制作彩钢瓦房顶的骨架,如果遇到解决不了的问题可以咨询我们。
  In the future construction project, the constructors hope to make the framework of the colored steel tile roof in strict accordance with the methods mentioned above. If there are problems that cannot be solved, please consult us.
此文关键词:

推荐阅读/ Recommended reading

  彩钢瓦房顶的骨架可谓是建筑的核心,因此对于它的制作方法有着高标准、高要求,本文就为大家介绍了如何制作彩钢瓦房顶的骨架,希望施工

岩棉复合板隔热材料应该注意什么? 2020-05-07
使用济南彩钢板做水槽的好处有哪些? 2020-05-05
304材质彩钢板为什么带磁性? 2020-04-30
彩钢钢结构工程被大量用房采用! 2020-04-28